A quick payback water pipe sealing tester. the special feature are
1, High sensitivity can detect 1-2 cc/hour water leak in a pipe nework.
2, High test speed 10-70 mins, normal residence will take 10-15 mins ONLY.
3, light weight, portable, easy ma
Operation guide
The system consist of 4 parts
1, test main body
2, battery, power connector x2 (one for charger, one for battery power) and one charger.
3. pressure sensor, pipe adaptor,
4. air pressure source adaptor, O-ring, USB connector.
Testing mode
1. medium water leak test
By air, total pipes volume under test
2. 15 liters
3. 30 liters
4. 50 liters
5. 80 liters
6. 100 liters
7. pressure measurement
total 7 modes, in turns by left first bottom(Mode) and set by middel bottom(Selection),
By Air (recommendation for new construction as easy to operate and clean)
After fill in either air by pressure source normally by air compressor, up to 5 Kgf/cm2(10% tolerance),
wait 2 minutes let system pressure stabilized, depress right bottom (Start Test)
The Leak test have 2 cycles, cycle 1 is "warm up" period time depends on the mode from 10 minutes to 20 minutes
cycle 2 is "Testing" , time is varies from 10 minutes to 60 mintes depends on test mode.
By water (for existing pipe under service, as filled water in operation, normally it is for building in service)
Use existing system pressure no need use additional pumping.
close the values where you are sure it leaks e.g. toilet branch pipe.
Tets result
Sytem will show the test result at the end of test (if piping system quality have no leak) or fail, check piping on the way.